Create a new job
In the Data menu, select Project, then select the current project.
In the window that pops up, click New.
Name the job
Give your new job a name.
Uncheck Control points, localization, MM-GPS data.
Add a control point
In the Data menu, select Control > Control points.
Give your control point arbitrary jobsite coordinates. It is best not to use zeroes for any of the values to better ensure that there will be no negative coordinates.
Select the GPS tab.
Check the boxes Use horizontal and Use vertical.
After the GPS measurement has been taken, the latitude (Lat), longitude (Lon), and height (Hgt) fields will populate, and you are ready to work.
Control points cannot be measured with the tilt function enabled.
If this needs to be disabled, go to the Setup menu, and check the box Enable tilt mode in receiver.
Collect several additional control points on the jobsite in case the original control point is destroyed. Be sure to uncheck the boxes for Use horizontal and Use vertical in the Control Point GPS tab.
Collect several other reference points that can be checked into on subsequent days to ensure accuracy.