MAGNET Field: mmGPS Setup

Setting up and Starting mmGPS in MAGNET Field.


Log in or sign up for myTopcon to view this page:

MAGNET Field: mmGPS Setup

Setup the Profile

  • Click on [Configure][Survey] and [Select from Library] for GPS+ Configuration, then [Add] a new profile
  • Type in a name and choose the used Type (here we use Network RTK with VRS)
  • Click [Next]
  • Our rover is a Topcon product
  • Click [Next]
  • Set up Rover Receiver Model
  • Click on [Peripherals]
  • Enable mmGPS
  • Click on [Parameters]
  • Set port according to connection on your receiver.
  • Click on the Check and Check again to confirm your setting
  • Click [Next]
  • The SIM is here inserted in receiver, we use the modem in the receiver.
  • Alternatively you can insert SIM in controller or use Radio RTK.
  • Click [Next]
  • MAGNET Field uses the Advanced Communication setup. Installed modem driver (done with TRU menu [Modem Driver]) is required. Set Radio Modem to “Internal Cellular”.
  • Click [Next]
  • Follow the following menus like known until the end

Getting Started

  • Connect to the receiver
  • The transmitter symbol is colored yellow and the VRMS is within a few millimeters. Take attention to the antenna height if no dedicated mmGPS rover pole is used.
  • Congratulations, you are up and running with mmGPS using MAGNET Field