GTL-1000: How to use the Site Scan module in MAGNET Field Layout [VIDEO]

Need to scan a jobsite for an as-built? This video shows you step-by-step how to set up a site scan in MAGNET Field Layout using the GTL-1000.

Log in or sign up for myTopcon to view this page:
Sign In Sign Up

GTL-1000: How to use the Site Scan module in MAGNET Field Layout [VIDEO]

Scanning checklist

Before you start, make sure that you've done the following:

  1. Have a bluetooth connection to the GTL-1000
  2. Checked into control points (either through an Occupy/Backsight routine) or a resection
  3. Removed the lens cap
  4. Inserted an SD card into the GTL-1000

RELATED ARTICLES

MAGNET Collage: Creating and viewing panoramas from the GTL-1000

MAGNET Collage: Creating and viewing panoramas from the GTL-1000

This article covers how to create and view panoramas in MAGNET Collage captured by the GTL-1000.

See More

MAGNET Collage: Importing GTL-1000 scans

MAGNET Collage: Importing GTL-1000 scans

This quick guide covers the steps for bringing data from the GTL-1000 into MAGNET Collage.

See More

[WEBINAR] ProSeries: MAGNET Field Layout, seamless vertical construction Autodesk to Topcon workflows

[WEBINAR] ProSeries: MAGNET Field Layout, seamless vertical construction Autodesk to Topcon workflows

Tech talk overview to learn about software workflows between Autodesk Point Layout (APL) and MAGNET Field Layout, specifically for vertical construction.

See More