MAGNET Field: Correct base station

Start by setting all the connections between the base receiver and the rover receiver. Find a full description in this article: MAGNET Field: Basic Training - GNSS configuration.

The General tab of the Connections dialog box allows you to change the type of the device to work and to select a job configuration before connecting to the device. 

1. Select the Base radio button and click Connect.
2. Select the base receiver in the Select Receiver dialog box.
3. If a PIN has been defined for that receiver, enter it in the Device info field.
4. Click Connect.

After establishing a connection with the base receiver, it is now possible to set up and start that same base station.

1. From the main window, click Setup.
2. Click Start Base.
3. Enter the name of the Point where the base receiver is located. 
4. Select the Code for the point from the drop-down list.
5. Enter the antenna height, and set the type of height measurement (vertical or slant).
6. Measure the current position by clicking the Measure button.
7. Click the Start Base button to start the receiver as the base transmitting the correction data.

Once the base receiver is started, it's now possible to connect to the rover receiver.

1. Click Yes to open the rover Connections dialog box.
2. The default selection is Rover.
3. Click Connect.
4. Select the rover receiver form the devices list.
5. If a PIN has been defined for that receiver, type it in the Device info field.
6. Click Connect.

MAGNET Field is now ready to be used for surveying.

1. In the main window, click Survey.
2. Click Topo to start your survey.

To access the Correct Base function, follow these steps:

1. In the main window, click Setup.
2. Click Correct Base.
3. Select the Topo Pt either from Map, List, or Measure it on the fly.
4. Select your Known Pt from Map or List.
5. Click the green check mark Accept button.
6. Click Yes to accept the offsets.