MAGNET Field: Basic Training - GNSS Configuration

0 0

Access Survey Configurations

  • Select Configure >> Survey

Equipment Configuration Library

  • Under GPS+ Configuration, choose Select from Library
  • Select Add

Create GNSS Configuration

  • Give the configuration a name that describes the hardware combination such as HiPer SR LongLINK
  • Choose RTK for the Type and select Next
  • Select Topcon as the Manufacturer for both base and rover
  • Select Next

Configure Base Receiver

  • Checkmark Ext. Receiver and choose Bluetooth as the communication method
  • Choose the desired receiver model such as HiPer SR
  • Enter the serial number of the base receiver (optional)
  • Leave the default elevation mask set to 13 degrees
  • Choose RTCM 3.x as the RTK Format
  • The correct antenna will be automatically selected based on the receiver model
  • Enter in the correct base antenna height, if using a fixed height tripod enter 2m
  • Select Next  

 

Configure Base Radio

  • Choose LongLink™ for the Model
  • Select Next

 

Configure Rover Receiver

  • Checkmark Ext. Receiver and choose Bluetooth as the communication method
  • Choose the desired receiver model such as HiPer SR
  • Enter the serial number of the base receiver (optional)
  • Leave the default elevation mask set to 13 degrees
  • Choose RTCM 3.x as the RTK Format
  • The correct antenna will be automatically selected based on the receiver model
  • Enter in the correct rover antenna height, if using a fixed height tripod enter 2m
  • Select Next  

 

Configure Rover Radio

  • Select the Receiver radio button for the Connect to method
  • Choose LongLink™ for Model
  • Select Next

At this point the main configutation settings have been established. Select the green checkmark button in the top-right three times to finish or proceed through the remainder of the configuration screens to establish personal preferences.