MAGNET Field: How to output NMEA messages from a rover receiver

This quick guide shows you the steps for outputting NMEA messages from your rover receiver.

Acceda o inscríbase en myTopcon para ver esta página:

Adding NMEA output to your existing configuration

To add NMEA output, go to Configure > Survey > Edit.

Click Next until you reach the Rover Receiver page.

Select your desired receiver model. In this example, it is a GR-5, but this workflow applies to a HiPer HR and HiPer VR.

Click on Peripherals.

Check the NMEA Ports box, and set it to the number of desired ports.

These are NMEA messages supported by Topcon.